This is a warning indicating that there is some issue with the steering system of your Ford. The problem can be a simple one such as low fluid levels or might be a serious one like a power steering pump failure. Anyhow you must take some proper steps to avoid any serious accident in such case.
What Are The Causes Of “Steering Assist Fault Service Required”?
There could be many reasons for the steering assist fault depending upon the type of Ford you are using and also its condition.
1. Software Problem
Well, this is not a serious issue but it is seen in some of the Fords such as Ford f150 that there is some problem with the software or the computer system of the car which triggers the “Steering assist fault Service required message.”
2. Power Steering Pump Failure
Your Ford’s power steering system includes a pump that applies pressure to hydraulic fluid, making turning and handling easier. When there is a problem with the power steering pump, the steering becomes heavy and difficult to turn because fluid won’t flow as it should. This can lead to a whining sound during steering and hydraulic leaks in your Fords such as Fusion and Ford Escape.
3. Leakage in Hydraulic Fluid
The fluid in the power steering system of your Ford i.e. Ford f150 or other helps to make the turning of the steering easy and smooth. If this fluid gets low or leaks due to some issue. it causes the steering to become stiff.
4. Torque Sensor Problem
Another cause of triggering the steering assist fault service required message is the failed torque sensor of your Ford. A torque sensor is necessary for monitoring the angle at which you are turning the wheel. If there’s an issue with it, the driver would experience failed traction and poor control. This immediately triggers the steering assist fault service required message to appear on the screen. It’s important to address this problem right away.
5. Problem with the Power Steering Belt
Different models of Fords have different types of steering belts such as Ford Focus has a Serpentine belt while the Ford Escape 2005 has a V-belt. The power steering belt helps to transfer power from the car’s main engine pulley to the steering pump. When the steering belt is damaged or worn out this can result in poor functioning of your Ford steering assist.
How Can Deal With The Ford Steering Assist Fault?
If your screen of the Ford dashboard is showing “Steering assist fault service required”, it might be because of the above-mentioned reasons. I suggest you follow the steps to handle the Ford steering assist fault.
- First of all, you need to reset the Ford steering assist. How can you reset your Ford steering assist? Well, it is quite simple. You have to turn off your car ignition for a few seconds and then turn it back again.
- If there is a hydraulic fluid issue then you need to consult a repair garage. The leakage must be fixed before refiling the fluid. However, changing the hydraulic fluid at regular intervals is a good way to ensure. You can find on the user manual of your Ford how often you need to change the fluid.
- If there is a failed torque sensor then you need to replace it. You have to disassemble the whole wheel. You can do it by yourself or get it done at a workshop.
- If there is a problem with the power steering pump then you need to run a scan. It might need a replacement.
- If your steering belt is failing then you need to replace it. You can do it by yourself if you have a little knowledge about the type and working of the belt of your Ford.
Similar Posts:
Conclusion:
When using Fords or other vehicles, it is inevitable to avoid all problems. So, we must be ready to deal with them. I hope after this article you’ll be able to deal with your Ford assist fault.
